Претраживање
Приказ резултата 81-90 од 193
Analysis and modeling of sintering of Sr-hexaferrite produced by PIM technology
(Belgrade : International Institute for the Science of Sintering, 2011)
The powder injection moulding (PIM) technology is lately becoming more and more significant due to complex design possibilities and good repeatability. This technology requires optimization of all steps starting with ...
Surface analysis of bismuth titanate by Auger and X-ray photoelectron spectroscopy
(Elsevier, 2009)
The Auger and XPS technique has been used for investigation in the surface of bismuth titanate (Bi4Ti3O12) (BIT) ceramics obtained by reactive sintering from Bi2O3 and TiO2 oxides. All peaks characteristic for bismuth, ...
BaTiO3 – ceramics and Fractal Microstructure Analyses
(Belgrade : Serbian Ceramic Society, 2014)
Ceramics grain structure is difficult to describe by using traditional analytical methods based on Euclidean geometry. Using the fractal geometric/analytic methods instead, the new approach is offered in this paper. There ...
3 Structural, morphological and electrical properties of sintered Fe2O3/TiO2 nanopowder mixtures
(Belgrade : Institute of Technical Sciences of SASA, 2013)
Starting nanopowders of TiO2 (anatase 99.7%) and a-Fe2O3 (hematite) were mixed in the weight ratio 60:40 and 40:60. Green samples were sintered in the temperature range 750-1250oC in air. Structural, morphological and ...
Structural analyses of sintered MT and BZT ceramics
(Belgrade : Serbian Society for Microscopy, 2010)
Development of dielectric materials is increasing with a rapid progress in mobile and satellite communications systems, where magnesium titanates find their place owing to good dielectric properties. Recently it has been ...
Influence of different bonding and fluxing agents on the sintering behavior and dielectric properties of steatite ceramic materials
(Elsevier, 2017)
The focus of the study was on providing insights into interconnections between sintering and development of the crystalline microstructure, and consequently variations in dielectric behavior of four steatites fabricated ...
Characterisation of Mn0.63Zn0.37Fe2O4 powders after intensive milling and subsequent thermal treatment
(Belgrade : Serbian Ceramic Society, 2016)
Commercial Mn-Zn powder (Mn0.63Zn0.37Fe2O4, 93 wt. % and Fe2O3 7 wt. %) was milled 0.5, 1, 2 and 4 hours in a planetary ball mill. Powders were characterized with XRD, SEM and particle seizer. Subsequent heating was monitored ...
Electret state in Bi4Ti3O12 ceramics
(Elsevier, 2010)
The effect of thermal treatment atmosphere (argon, air or oxygen) on the electret behavior of bismuth titanate (Bi4Ti3O12) ceramics was investigated. Polycrystalline ferroelectric ceramics were prepared by reactive liquid ...
Hydroxyapatite nanopowders prepared in the presence of zirconium ions
(Elsevier, 2014)
Hydroxyapatite nanopowders were prepared in the presence of different concentrations of zirconium ions. Such crystallization conditions yielded significantly reduced particle size and increased specific surface area. Cell ...
Preparation and properties of BaTi1-xSnxO3 multilayered ceramics
(Journal of the European Ceramic Society, 2007)
BaTi1-xSnxO3 (BTS) powders, with x ranging from 0 to 0.15, were synthesized by solid-state reaction technique. The powders were pressed and sintered at 1370 degrees C. Obtained BTS ceramics were investigated by X-ray ...