Претраживање
Приказ резултата 81-90 од 194
Densification rate and phase structure changes during sintering of zinc titanate ceramics
(Elsevier, 2009)
Densification rate and phase structure changes during sintering of nanosized ZnTiO3 were studied. Sintering was performed in a dilatometer in two regimes: the first to 900 °C (heating rates 5, 10 and 15 °C/min) and the ...
The Influence of Mechanical Activation on Sintering Process of BaCO3-SrCO3-TiO2 System
(Belgrade : Serbian Ceramic Society, 2012)
In this article the influence of mechanical activation on sintering process of barium-strontiumtitanate ceramics has been investigated. Both non-activated and mixtures treated in planetary ball mill for 5, 10, 20, 40, 80 ...
Influence of MgO addition on the synthesis and electrical properties of sintered zinc-titanate ceramics
(Elsevier, 2009)
Starting mixtures of ZnO, TiO2 and MgO (0, 1.25 and 2.5 wt.% MgO) powders were mechanically activated for 15 min in a planetary ball mill. The powders obtained were sintered non-isothermally to temperatures between 800 and ...
The effect of mechanical activation on synthesis and properties of MgAl2O4 ceramics
(Elsevier, 2019)
Magnesium aluminate, MgAl2O4 and other alumina-based spinels are ceramics with high hardness, high melting point and mechanical strenght. Spinels can also be used as dielectrics in microwave applications. The goal of this ...
Synthesis, characterization and sintering properties of Zr-doped hydroxyapatite
(Belgrade : Institute of Technical Sciences of the Serbian Academy of Sciences and Arts, 2011)
Improving of material characteristics could be achieved in different ways, but it is always connected with the issue of impairing the other functional properties. Hydroxyapatite bioceramics lacks of insufficient mechanical ...
Microstructure changes caused by thermal etching of sintered ZnTiO3
(2014)
Polishing and thermal etching was performed on ZnTiO3sintered ceramic. Two set of specimens were recorded, on higher 1200oC/1100oC sintered/etched, and lower 900oC/800oC sintered/etched. Phase composition, crystallite sizes ...
Analysis and modeling of sintering of Sr-hexaferrite produced by PIM technology
(Belgrade : International Institute for the Science of Sintering, 2011)
The powder injection moulding (PIM) technology is lately becoming more and more significant due to complex design possibilities and good repeatability. This technology requires optimization of all steps starting with ...
Surface analysis of bismuth titanate by Auger and X-ray photoelectron spectroscopy
(Elsevier, 2009)
The Auger and XPS technique has been used for investigation in the surface of bismuth titanate (Bi4Ti3O12) (BIT) ceramics obtained by reactive sintering from Bi2O3 and TiO2 oxides. All peaks characteristic for bismuth, ...
BaTiO3 – ceramics and Fractal Microstructure Analyses
(Belgrade : Serbian Ceramic Society, 2014)
Ceramics grain structure is difficult to describe by using traditional analytical methods based on Euclidean geometry. Using the fractal geometric/analytic methods instead, the new approach is offered in this paper. There ...
3 Structural, morphological and electrical properties of sintered Fe2O3/TiO2 nanopowder mixtures
(Belgrade : Institute of Technical Sciences of SASA, 2013)
Starting nanopowders of TiO2 (anatase 99.7%) and a-Fe2O3 (hematite) were mixed in the weight ratio 60:40 and 40:60. Green samples were sintered in the temperature range 750-1250oC in air. Structural, morphological and ...