Претраживање
Приказ резултата 31-40 од 84
Phase Formation at the Sintering of Sa, Zn, Ti Oxides
(Kiev, 2009)
Complex compounds with oxide phases of Ba, 2n, and 11 are widely used in instrument engineering. It is also important to find such production routes for ceramics, which provide their stable structure and properties. Phase ...
Full density calcium phosphate bioceramics from nanopowders by sintering
(2010)
Poster presented at the Adriatic School of Nanoscience – ASON-1, Dubrovnik, Croatia, September 19–23, 2010
The Influence of Mechanical Activation on Sintering Process of BaCO3-SrCO3-TiO2 System
(Belgrade : Serbian Ceramic Society, 2012)
In this article the influence of mechanical activation on sintering process of barium-strontiumtitanate ceramics has been investigated. Both non-activated and mixtures treated in planetary ball mill for 5, 10, 20, 40, 80 ...
Synthesis, characterization and sintering properties of Zr-doped hydroxyapatite
(Belgrade : Institute of Technical Sciences of the Serbian Academy of Sciences and Arts, 2011)
Improving of material characteristics could be achieved in different ways, but it is always connected with the issue of impairing the other functional properties. Hydroxyapatite bioceramics lacks of insufficient mechanical ...
Microstructure changes caused by thermal etching of sintered ZnTiO3
(2014)
Polishing and thermal etching was performed on ZnTiO3sintered ceramic. Two set of specimens were recorded, on higher 1200oC/1100oC sintered/etched, and lower 900oC/800oC sintered/etched. Phase composition, crystallite sizes ...
BaTiO3 – ceramics and Fractal Microstructure Analyses
(Belgrade : Serbian Ceramic Society, 2014)
Ceramics grain structure is difficult to describe by using traditional analytical methods based on Euclidean geometry. Using the fractal geometric/analytic methods instead, the new approach is offered in this paper. There ...
3 Structural, morphological and electrical properties of sintered Fe2O3/TiO2 nanopowder mixtures
(Belgrade : Institute of Technical Sciences of SASA, 2013)
Starting nanopowders of TiO2 (anatase 99.7%) and a-Fe2O3 (hematite) were mixed in the weight ratio 60:40 and 40:60. Green samples were sintered in the temperature range 750-1250oC in air. Structural, morphological and ...
Structural analyses of sintered MT and BZT ceramics
(Belgrade : Serbian Society for Microscopy, 2010)
Development of dielectric materials is increasing with a rapid progress in mobile and satellite communications systems, where magnesium titanates find their place owing to good dielectric properties. Recently it has been ...
Characterisation of Mn0.63Zn0.37Fe2O4 powders after intensive milling and subsequent thermal treatment
(Belgrade : Serbian Ceramic Society, 2016)
Commercial Mn-Zn powder (Mn0.63Zn0.37Fe2O4, 93 wt. % and Fe2O3 7 wt. %) was milled 0.5, 1, 2 and 4 hours in a planetary ball mill. Powders were characterized with XRD, SEM and particle seizer. Subsequent heating was monitored ...
Structural and Electrical Properties of Sintered Zinc-titanate Ceramics
(2005)
Poster presented at the ELECTROCERAMICS X, June 18-22, 2006, Toledo, Spain