Pretraživanje
Prikaz rezultata 1-10 od 22
The contribution of fractal nature to BaTiO3-ceramics microstructure analysis
(Elsevier, 2012)
The structure of BaTiO3 based materials can be controlled by using different technological parameters and different additives. In this paper, microstructure and dielectrical properties of Er2O3 doped BaTiO3-ceramics, ...
Effect of consolidation parameters on structural, microstructural and electrical properties of magnesium titanate ceramics
(Elsevier, 2016)
The aim of this study is to explore the influence of the processing route on the structural and physical properties of bulk MgTiO3 ceramics. Commercially available MgO and TiO2 powders were mechanically activated in a ...
The influence of mechanical activation on structural evolution of nanocrystalline SrTiO3 powders
(Elsevier, 2017)
Structural changes caused by mechanical activation of SrTiO3 powders were investigated using a variety of methods. Average crystallite size continuously decreased with increased activation time to around 20 nm after 120 ...
Fractal approach to BaTiO3-ceramics micro-impedances
(Elsevier, 2015)
A new approach, based on fractal geometry and correlation between microstructure-nanostructure and rare-earth properties and other additives doped BaTiO3-ceramics and electronics properties, is applied. The grain contacts ...
Microstructure and mechanical properties of disperse Ni-Co alloys electrodeposited on Cu substrates
(Elsevier, 2010)
The nickel and cobalt disperse alloy deposits of five different compositions were obtained by electrodeposition on Cu substrates in the galvanostatic regime from an ammonium sulfate-chloride solution. The effect of cathodic ...
Synthesis and properties of hydroxyapatite/poly-L-lactide composite biomaterials
(Oxford : Elsevier Sci Ltd, 1999)
Calcium hydroxyapatite (HAp) and poly-L-lactide (PLLA) were synthesized chemically. The obtained HAp was of high purity and, after special thermal treatment, of high crystallinity as well. Synthesis of PLLA was performed ...
Compressive strength and microstructure of ordinary cured and autoclaved cement-based composites with mechanically activated kaolins
(Elsevier, 2018)
The effects of two different mechanically activated kaolins, AKV (61% kaolinite, 14% quartz and 16% mica) and AKG (51.6% kaolinite and 40.6% quartz) on the compressive strength of cement composites and microstructure of ...
Inert atmosphere processing of hydroxyapatite in the presence of lithium iron phosphate
(Journal of the European Ceramic Society, 2018)
The present study describes sintering behaviour of hydroxyapatite (HAp) upon addition of lithium iron phosphate (LFP) (1-10 wt.%) system in inert (Ar) atmosphere. The interaction between materials and melting of LFP ...
Densification rate and phase structure changes during sintering of zinc titanate ceramics
(Elsevier, 2009)
Densification rate and phase structure changes during sintering of nanosized ZnTiO3 were studied. Sintering was performed in a dilatometer in two regimes: the first to 900 °C (heating rates 5, 10 and 15 °C/min) and the ...
The effect of mechanical activation on synthesis and properties of MgAl2O4 ceramics
(Elsevier, 2019)
Magnesium aluminate, MgAl2O4 and other alumina-based spinels are ceramics with high hardness, high melting point and mechanical strenght. Spinels can also be used as dielectrics in microwave applications. The goal of this ...