Extra phase-pure Li4Ti5O12 spinel with particle sizes less than 500 nm was synthesized by solid state reaction of mechanochemicaly activated mixture of nano anatase and Li2CO3 for a very short annealing time, 4 h at 800°C. ...

Barium strontium titanate powders with different Ba:Sr ratios were investigated to determine the influence of the initial composition of powder mixture on microstructural properties and sintering kinetics. It was determined ...

The effects of small amounts (0.5; 1.0 and 1.5 mol. %) of bismuth oxide on the microstructure and electrical properties of ZnO-SnO2 ceramics have been studied. Starting powders of ZnO and SnO2 were mixed in the molar ratio ...

Hydrothermally synthesized one-dimensional and two-dimensional nanocrystals of VO2 undergo phase transition around 65°C, where temperature and mechanism of phase transition are dependent on dimensionality of nanocrystals. ...

In this work the development of the spinel phase in the ZnO-Cr2O3 system was discussed from the viewpoint of the synthesis-structure relationship. The nanostructure evolution in particles obtained either via solution-based ...

Doped BaTiO 3-ceramics is very interesting for their application as PTCR resistors, multilayer ceramic capacitors, thermal sensors etc. Ho doped BaTiO 3 ceramics, with different Ho 2O 3 content, ranging from 0.01 to 1.0 ...

Far infrared spectra of sintered PbTe doped with boron were analyzed. The measured infrared spectra were fitted using a modified plasmon-phonnon interaction model with two additional oscillators (at about 195 cm-1 and 285 ...

Thermal diffusivity and electric transport properties of fourteen years old superconducting YBa2Cu3O7-x pellets were obtained using the photoacoustic transmission technique and then compared with freshly made superconducting ...

Barium titanate (BaTiO3) attracts high scientific and technological attention due to good dielectric and electromechanical properties. Although BaTiO3 is one of the most frequently investigated ferroelectric materials, the ...

The surface topography analysis via fractals as a means of explanation of composite materials mechanical and microstructural characteristics has hardly been reported so far. This study proposes a method of fractal analysis ...