Претраживање
Приказ резултата 11-20 од 37
Science of Sintering in the XXI Century : book of abstracts / X World Round Table Conference on Sintering
(Belgrade : Institute of Technical Sciences of SASA; International Institute for the Science of Sintering; Serbian Academy of Sciences and Arts, 2002)
Science of Sintering in the XXI Century : book of abstracts / X World Round Table Conference on Sintering [3-6 September 2002 Belgrade, Yugoslavia] ; [organized by] Serbian Academy of Sciences and Arts and International ...
Phase Formation at the Sintering of Sa, Zn, Ti Oxides
(Kiev, 2009)
Complex compounds with oxide phases of Ba, 2n, and 11 are widely used in instrument engineering. It is also important to find such production routes for ceramics, which provide their stable structure and properties. Phase ...
Uticaj aditiva na sinterovanje sistema ZnO-TiO2 saglasno trijadi sinteza-struktura-svojstva
(Belgrade : University of Belgrade, Faculty of Physical Chemistry, 2007)
U okviru ove doktorske disertacije detaljno i sistematski je proučen uticaj aditiva magnezijum oksida na sintezu i sinterovanje sistema ZnO-TiO2. Smeša prahova ZnO, TiO2, MgO (0, 1,25 i 2,50 masenih % MgO), mehanički je ...
ZnO varistors prepared by direct mixing of constituent phases
(Sendai : Japan Institute of Metals, 2000)
ZnO varistors with non-linearity coefficients reaching 50 and low values of the leakage current (approximately 0.01 A/m2), were obtained by a method referred to as `direct mixing of constituent phases'. The method is based ...
Densification rate and phase structure changes during sintering of zinc titanate ceramics
(Elsevier, 2009)
Densification rate and phase structure changes during sintering of nanosized ZnTiO3 were studied. Sintering was performed in a dilatometer in two regimes: the first to 900 °C (heating rates 5, 10 and 15 °C/min) and the ...
Influence of MgO addition on the synthesis and electrical properties of sintered zinc-titanate ceramics
(Elsevier, 2009)
Starting mixtures of ZnO, TiO2 and MgO (0, 1.25 and 2.5 wt.% MgO) powders were mechanically activated for 15 min in a planetary ball mill. The powders obtained were sintered non-isothermally to temperatures between 800 and ...
Surface analysis of bismuth titanate by Auger and X-ray photoelectron spectroscopy
(Elsevier, 2009)
The Auger and XPS technique has been used for investigation in the surface of bismuth titanate (Bi4Ti3O12) (BIT) ceramics obtained by reactive sintering from Bi2O3 and TiO2 oxides. All peaks characteristic for bismuth, ...
Preparation and properties of BaTi1-xSnxO3 multilayered ceramics
(Journal of the European Ceramic Society, 2007)
BaTi1-xSnxO3 (BTS) powders, with x ranging from 0 to 0.15, were synthesized by solid-state reaction technique. The powders were pressed and sintered at 1370 degrees C. Obtained BTS ceramics were investigated by X-ray ...
Far infrared properties of sintered PbTe doped with boron
(Belgrade : International Institute for the Science of Sintering, 2007)
Far infrared spectra of sintered PbTe doped with boron were analyzed. The measured infrared spectra were fitted using a modified plasmon-phonnon interaction model with two additional oscillators (at about 195 cm-1 and 285 ...
Far infrared reflection spectroscopy of Zn2SnO4 ceramics obtained by sintering mechanically activated ZnO-SnO2 powder mixtures
(Elsevier Sci Ltd, Oxford, 2007)
A mixture of starting ZnO and SnO2 powders (molar ratio 2: 1) were mechanically activated for 10, 40, 80 and 160 min in a planetary ball mill and then isothermally sintered at 1300 degrees C for 2 h in order to obtain ...