Now showing items 71-80 of 172
Structural and electrical properties of barium-zinc-titanate ceramics sintered at 1300ºc
(Belgrade : Institute of Technical Sciences of SASA, 2010)
The aim of this work was an investigation of structural and electrical properties of sintered barium-zinc-titanate ceramics. Mixtures of BaCO3, ZnO and TiO2 were mechanically activated in a planetary ball mill up to 80 ...
Properties of Magnesium Titanate Ceramic Obtained by Two Stage Sintering
Poster presented at the III Serbian Ceramic Society Conference, 29th September - 1st October, Belgrade, 2014
Influence of nitrogen and air atmosphere during thermal treatment on micro and nano sized powders and sintered TiO2 specimens
(Science of Sintering, 2014)
The influence of air and nitrogen atmosphere during heating on TiO2 nano and micro sized powders as well as sintered polycrystalline specimens was analyzed. Sintering of TiO2 nano and micro powders in air atmosphere was ...
Influence of Point Defects Concentration on Densification Process and Optical Properties of Sintered ZnO Ceramics
(Belgrade : Materials Research Society of Serbia, 2015)
Zinc oxide is one of the most studied materials due to its potential applications in electronics, optoelectronics and spintronics. In the forms of single crystal and thin-film ZnO could be used as UV and blue light emitter, ...
Pseudobrookite TiFe2O5 nanostructured thick films
(Belgrade : Institute of Technical Sciences of SASA, 2015)
TiO2 (anatase) and Fe2O3 (hematite) nanopowders were mixed in the weight ratio 1:1.5 and 1:2 and homogenized in a planetary ball mill for an hour. After that pastes were prepared of the two powder mixtures, organic vehicle ...
Influence of mechanical activation on structural and electrical properties of sintered MgTiO3 ceramics
(Belgrade : International Institute for the Science of Sintering, 2009)
The aim of this work was to analyze the influence of mechanical activation on the MgCO3-TiO2 system. Mixtures of MgCO3-TiO2 were mechanically activated for 15, 30, 60 and 120 minutes in a planetary ball mill and after that ...
Sintering effects on microstructure and dielectric properties of CCTO ceramics
(Belgrade : Materials Research Society of Serbia, 2012)
A perovskite-type compound, calcium copper titanate (CaCu3Ti4O12, CCTO) attracted ever increasing attention for its practical applications in microelectronics, especially for preparation of capacitors and memory devices. ...
The influence of mechanical activation on the electrical properties of Ba0.77Sr0.23TiO3 ceramics
(Ceramics International, 2014)
Ferroelectric barium strontium titanate (Ba0.77Sr0.23TiO3), BST, was prepared by solid-state reactions using as the starting compounds powder of barium carbonate (BaCO3), strontium carbonate (SrCO3) and titanium dioxide ...
Application of the master Sintering Curve Theory to Sintering of BTS FGMs
Poster presented at PHYSICAL CHEMISTRY 2008. 9th International Conference on Fundamental and Applied Aspects of Physical Chemistry, Belgrade, September 24-26, 2008
New Frontiers: Miniaturization and Higher Level BaTiO3 -Ceramics Microelectronics Circuits Integration
(Belgrade : Serbian Ceramic Society, 2012)
Since that the scientific and technological efforts to further miniaturization, "better packaging" and higher levels of integration of electronic components and subsystems, and modern microelectronics devices are increasingly ...