Претраживање
Приказ резултата 61-70 од 107
Sintering process influence on microstructure and intergranular impedance of rare-earth modified BaTiO3-ceramics
(Belgrade : International Institute for the Science of Sintering, 2011)
Sintering process is a complex of different synergetic effects during the ceramics materials consolidation. The microstructural level properties control is very important as a stage in advanced materials prognosis. SEM ...
Ho2O3 Additive Effects on BaTiO3 Ceramics Microstructure and Dielectric Properties
(Belgrade : International Institute for the Science of Sintering, 2012)
Doped BaTiO 3-ceramics is very interesting for their application as PTCR resistors, multilayer ceramic capacitors, thermal sensors etc. Ho doped BaTiO 3 ceramics, with different Ho 2O 3 content, ranging from 0.01 to 1.0 ...
Microstructural evolution and electric properties of mechanically activated BaTiO3 ceramics
(Oxford : Elsevier Sci Ltd, 2007)
Ceramic materials with a perovskite related structures such as non-doped and doped barium titanate ceramics are attracting much interest for their application as capacitor dielectrics, resistors, thermal sensors, etc. Since ...
Synthesis of BaTiO3 from a mechanically activated BaCO 3-TiO2 system
(Belgrade : International Institute for the Science of Sintering, 2008)
In this article the solid state reaction of BaTiO3 formation from a mechanically activated BaCO3-TiO2 system has been investigated. An equimolar mixture of BaCO3 and TiO2 powders was activated in a planetary ball mill in ...
TiO2 nanotubes film/FTO glass interface: Thermal treatment effects
(ETRAN, 2022)
Pure Ti films deposited by radio-frequency magnetron sputtering on FTO glass were anodized to fabricate TiO2 nanotubes (NTs) arrays. The TiO2 NTs/FTO samples were sintered at 450, 550 and 630°C, in ambient air. The thermal ...
The effect of ball milling on properties of sintered manganese-doped alumina
(Elsevier, 2019)
Alumina-based compounds have many technological applications and attract great attention even after decades of investigation, due to their good chemical, electrical, and mechanical properties. A mixture of several alumina ...
Densification, Microstructure, and Electrical Properties of BaTiO3 (BT) Ceramics Prepared from Ultrasonically De-Agglomerated BT Powders
(Taylor & Francis, 2009)
In this study, a correlation between densification, microstructure, and electrical properties of BaTiO3 (BT) ceramics prepared from ultrasonically de-agglomerated BT powders has been analyzed. BT powders with the same ...
Synthesis and sintering of high-temperature composites based on mechanically activated fly ash
(Belgrade : International Institute for the Science of Sintering, 2012)
Amount of fly ash which is and yet to be generated in the coming years highlights the necessity of developing new methods of the recycling where this waste can be reused in significant quantity. A new possibility for fly ...
Investigation of zinc stannate synthesis using photoacoustic spectroscopy
(Belgrade : International Institute for the Science of Sintering, 2007)
Mixtures of ZnO and SnO2 powders, with molar ratio of 2:1, were mechanically activated for 40, 80 and 160 minutes in a planetary ball mill. The resulting powders were compacted into pellets and non-isothermally sintered ...
Mg/Cu co-substituted hydroxyapatite – Biocompatibility, mechanical properties and antimicrobial activity
(Elsevier, 2019)
The aim of this study was to improve the mechanical properties and to optimize antimicrobial activity of hydroxyapatite (HAP) by simultaneous doping with Mg and Cu ions in order to obtain material that would be able to ...