The aim of this work is an investigation of isothermal sintering kinetics by observing the reduction of the specific surface area of ZnO. Zinc oxide powder is sintered isothermally in air for 5 to 120 min at temperatures ...

Morphology control in the (Na,H)2TinO2n+1 system has been achieved by introducing particle size as the key parameter during hydrothermal synthesis. The process is applied for the synthesis of TiO2-based nanofibers and ...

Single crystal samples of lead telluride doped with Pr were produced using the Bridgman method. Far infrared spectra of the samples doped with 0.15 at%, 0.25 at% and 0.6 at% Pr are presented. The experimental data were ...

New way to improve the surface properties of the inorganic and organic materials via nanotubes treatment process has been shown. It has been testified that the surface mechanical hardness of the MgF2, LiF, etc. materials ...

Poster presented at the 11th Conference of the Materials Research Society of Serbia - YUCOMAT 2009, Herceg Novi, Montenegro, August 31 – September 4, 2009.

Istraživanje je sprovedeno sa ciljem da se dokaže aktivnost alkalne fosfataze, lokalizovane u dekalcifikovanoj kosti, uzete sa leve strane mandibule pacova, u kojoj je arteficijalno napravljen defekt i implantiran nano ...

The Auger and XPS technique has been used for investigation in the surface of bismuth titanate (Bi4Ti3O12) (BIT) ceramics obtained by reactive sintering from Bi2O3 and TiO2 oxides. All peaks characteristic for bismuth, ...

The aim of this work was to analyze the influence of mechanical activation on the MgCO3-TiO2 system. Mixtures of MgCO3-TiO2 were mechanically activated for 15, 30, 60 and 120 minutes in a planetary ball mill and after that ...

Starting mixtures of BaCO3 •ZnO and Ti02 were mechanically activated for 0,5, 10,20.40 and 80 minutes in a planetary ball mill. The powders obtained were sintered isothermally to temperatures between 1000 and 1300 °C. The ...