Претраживање
Приказ резултата 11-20 од 23
Synthesis and characterization of zinc titanate nano-crystal powders obtained by mechanical activation
(Belgrade : International Institute for the Science of Sintering, 2005)
Development of dielectric materials for microwave frequencies is increasing with rapid progress in mobile and satellite communications systems, where zinc titanates have found application due to their semi-conducting and ...
Investigation of sintering kinetics of NiO using photo acoustic spectroscopy
(Belgrade : International Institute for the Science of Sintering, 2004)
Sintering kinetics of NiO was investigated using photo acoustic spectroscopy This method was used to follow the change of phase and amplitude of the photo acoustic signal of nickel-oxide samples sintered at 1373 K for ...
Far infrared properties of sintered PbTe doped with boron
(Belgrade : International Institute for the Science of Sintering, 2007)
Far infrared spectra of sintered PbTe doped with boron were analyzed. The measured infrared spectra were fitted using a modified plasmon-phonnon interaction model with two additional oscillators (at about 195 cm-1 and 285 ...
Reaction sintering of the 2ZnO-TiO2 system
(Belgrade : International Institute for the Science of Sintering, 2007)
Sintering kinetics of the mechanically activated ZnO-TiO2 system was studied. Mixtures of ZnO and TiO2 powders were mechanically activated using a high-energy ball mill for different time intervals from 0 to 300 minutes. ...
The effect of ageing on YBa2Cu3O7-x obtained by the photoacoustic method
(Belgrade : International Institute for the Science of Sintering, 2003)
Thermal diffusivity and electric transport properties of fourteen years old superconducting YBa2Cu3O7-x pellets were obtained using the photoacoustic transmission technique and then compared with freshly made superconducting ...
Intrinsic resistivity of sintered Nickel Manganite vs. powder activation time and density
(Belgrade : International Institute for the Science of Sintering, 2008)
In this work the DC resistivity of sintered nickel manganite NiMn2O4 (NTC thermistor material) was studied as a function of additional powder activation time in a planetary ball mill (0, 5, 15, 30, 45 and 60 min). The ...
Synthesis of BaTiO3 from a mechanically activated BaCO 3-TiO2 system
(Belgrade : International Institute for the Science of Sintering, 2008)
In this article the solid state reaction of BaTiO3 formation from a mechanically activated BaCO3-TiO2 system has been investigated. An equimolar mixture of BaCO3 and TiO2 powders was activated in a planetary ball mill in ...
Investigation of zinc stannate synthesis using photoacoustic spectroscopy
(Belgrade : International Institute for the Science of Sintering, 2007)
Mixtures of ZnO and SnO2 powders, with molar ratio of 2:1, were mechanically activated for 40, 80 and 160 minutes in a planetary ball mill. The resulting powders were compacted into pellets and non-isothermally sintered ...
Thermal diffusivity of sintered 12CaO-7Al2O3
(Belgrade : International Institute for the Science of Sintering, 2003)
The thermal diffusivity and some electrical transport properties of sintered 12CaO-7Al2O3 were determined using a photoacoustic method with a transmission detection configuration. The thermal diffusivity, coefficient of ...
A phenomenological analysis of sintering kinetics from the viewpoint of activated volume
(Belgrade : International Institute for the Science of Sintering, 2005)
The sintering kinetics of real systems has been viewed as a process of transport of activated volume. Activated volume is a parameter that can be used to describe mass transport during the sintering process. It defines the ...