Претраживање
Приказ резултата 171-180 од 2446
Characterization of mechanically activated ZnO powder
(Belgrade : Serbian Ceramic Society, 2013)
Materials based on ZnO structure have more frequently application as fillers in polymer ceramics nanocompozites. Performances of these materials depends on fillers morphology, surfaces texture and particles size. According ...
One-pot synthesis of biocompatible NaYF4:Yb,Er nanoparticles for cell labeling
(Belgrade : Materials Research Society of Serbia, 2018)
In modern medical research, great attention has been focused to the development of the new biomarkers which include up-converting nanoparticles (UCNPs). Their optical response is triggered by NIR radiation that achieves ...
Properties of Magnesium Titanate Ceramic Obtained by Two Stage Sintering
(Belgrade : Serbian Ceramic Society, 2014)
The aim of this paper was investigation of structural and electrical properties of magnesium titanate ceramic obtained mechanochemically and subjected to two stage sintering process. Mixtures of MgO and TiO2 were treated ...
Partitioning and purification of cellulases in aqueous two-phase system
(Tatranské Matliare : Slovak Society of Chemical Engineering, 2012)
Aqueous two-phase systems can be formed by mixing the solutions of two mutually incompatible polymers or polymer and salt above critical concentrations and represent media that are very well suited for the separation and ...
Effects of different mechanical treatments on structural changes of lignocellulosic waste biomass and subsequent Cu(II) removal kinetics
(Elsevier, 2019)
In this paper, the character of structural changes induced by different mechanical treatments to Prunus persica stones (PSs), and its subsequent effect on biosorption kinetics of Cu(II) were investigated. PSs were processed ...
Biodiesel synthesis and kinetic analysis based on MnCO3/Na silicate as heterogeneous catalyst
(Belgrade : Serbian Chemical Society, 2018)
Тhe MnCO3/Na silicate (Mn/Na/Si mole ratio of 4.65:1:1.65) catalyst in the form of solid particles with diameter of 0.99–1.99 mm was used as a catalyst for transesterification of soybean oil in batch autoclave at different ...
Preparation of LiFePO4/C composites by co-precipitation in molten stearic acid
(Journal of Power Sources, 2011)
The olivine type LiFePO4 is synthesized via a simple and inexpensive route by aqueous co-precipitation of an Fe(II) precursor material in molten stearic acid and subsequent heat treatment at different temperatures. Stearic ...
Exploring fractality of microcrystalline diamond films
(American Institute of Physics, 2018)
Diamond is renowned as a material with superlative physical qualities, most of which originate from the strong covalent bonding between its atoms. The possibility to deposit polycrystalline diamond films via chemical vapor ...
Measurement of Permittivity of Solid and Liquid Dielectrics in Coaxial Chambers
(Belgrade : National Society for Microwave Technique, Technologies and Systems and Serbia and Montenegro IEEE MTT-S Chapter, 2016)
We present two coaxial chambers for measurements of the complex permittivity of solid and liquid samples, in a frequency range that is in the transition between lower frequencies, here parallel-plate capacitor ...
Sinteza i karakterizacija BaTi 1-x Sn x O3 prahova i višeslojninh keramičkih materijala
(Belgrade : University of Belgrade, Faculty of Physical Chemistry, 2008)
BaTi1−xSnxO3 (BTS) prahovi (x od 0 do 0.15) sintetisani su reakcijom u čvrstom stanju. Određene su fizičke karakteristike sintetisanih BTS prahova i monomorfnih sinterovanih komponenata: srednja veličina čestica, raspodela ...