Претраживање
Приказ резултата 1-10 од 10
Preparation and characterization of Cu and Zn modified nickel manganite NTC powders and thick film thermistors
(Elsevier, 2013)
A simple ball milling/thermal treatment procedure was applied to obtain fine thermistor powders. Three different powder compositions were analyzed–Cu0.2Ni0.5Zn1.0Mn1.3O4, Cu0.25Ni0.5Zn1.0Mn1.25O4 and Cu0.4Ni0.5Mn2.1O4. XRD ...
Kinetics of crystallite size evolution by ball milling
(Belgrade : Association of the Chemical Engineers of Serbia, 2002)
One of the distinguishing features of mechanochemical treatment is crystallite size reduction. The crystallite size of the powder subjected to milling decreases to some minimal value characteristic for the given material. ...
The influence of mechanical activation on structural evolution of nanocrystalline SrTiO3 powders
(Elsevier, 2017)
Structural changes caused by mechanical activation of SrTiO3 powders were investigated using a variety of methods. Average crystallite size continuously decreased with increased activation time to around 20 nm after 120 ...
Influence of mechanical activation on synthesis of zinc metatitanate
(Belgrade : International Institute for the Science of Sintering, 2005)
Investigations of a ZnO-TiO2 binary oxide mixture during mechanical treatment were mainly focused on obtaining orthotitanate Zn2TiO4 with a spinel structure. Due to the specific way of energy transfer during mechanical ...
Mechanochemically Synthesized CaO ZnO Catalyst For Biodiesel Production
(Elsevier, 2012)
The transesterification of triglycerides (vegetable oil) with methanol using CaO·ZnO mixed oxides catalyst were conducted to produce FAME (Fatty Acid Methyl Esters, i.e. biodiesel). Catalyst was synthesized by ball milling ...
Geometrical and electrical properties of NTC polycrystalline thermistors vs. Changes of sintering parameters
(Belgrade : International Institute for the Science of Sintering, 2006)
NTC thermistor powder was made of a Mn, Ni, Fe and Co oxide mixture calcinated at 1050°C / 60 min. The powder was milled in a ball mill down to an average particle diameter of 0.9 μm. Small disc shaped pills of the powder ...
Synthesis and characterization of zinc titanate nano-crystal powders obtained by mechanical activation
(Belgrade : International Institute for the Science of Sintering, 2005)
Development of dielectric materials for microwave frequencies is increasing with rapid progress in mobile and satellite communications systems, where zinc titanates have found application due to their semi-conducting and ...
Structural characterization and electrical properties of sintered magnesium–titanate ceramics
(Elsevier, 2013)
In this article the influence of ball miling process on structure of MgO–TiO2 system, as well as the electrical properties of samples after sintering, was investigated. The mixtures of MgO–TiO2 powders were mechanically ...
Mechanochemical synthesis of gamma-Bi2O3
(Amsterdam : Elsevier, 2004)
A series of gamma-Bi2O3 phases doped with Zn, Si, Pb and Fe was prepared by mechanochemical treatment of corresponding oxide mixtures with a nominal composition 6Bi(2)O(3) (.) MOx (MOx = ZnO, SiO2, PbO) and 12Bi(2)O(3) (.) ...
Spark plasma sintering of magnesium titanate ceramics
(Ceramics International, 2024)
Magnesium titanate ceramics were prepared by reactive spark plasma sintering (SPS) at 1200 °C for 5 min. Prior to sintering, MgO and TiO2 powders were mixed by high energy ball milling (HEBM) for 15, 30, or 60 min. The ...