Претраживање
Приказ резултата 1-7 од 7
Reduction of the specific surface area of porous ZnO during sintering
(Čačak : Technical Faculty, 2007)
In this paper reduction of the specifice surface area of porous ZnO during sintering was analyzed. ZnO was sintered at temperatures from 673K to 1173K. Reduction of the specific surface area was observed as a function of ...
Science of Sintering in the XXI Century : book of abstracts / X World Round Table Conference on Sintering
(Belgrade : Institute of Technical Sciences of SASA; International Institute for the Science of Sintering; Serbian Academy of Sciences and Arts, 2002)
Science of Sintering in the XXI Century : book of abstracts / X World Round Table Conference on Sintering [3-6 September 2002 Belgrade, Yugoslavia] ; [organized by] Serbian Academy of Sciences and Arts and International ...
Phase Formation at the Sintering of Sa, Zn, Ti Oxides
(Kiev, 2009)
Complex compounds with oxide phases of Ba, 2n, and 11 are widely used in instrument engineering. It is also important to find such production routes for ceramics, which provide their stable structure and properties. Phase ...
Correlation between densification rate and microstructure evolution of mechanically activated BaTiO3
(Abingdon : Taylor & Francis Ltd., 2005)
Increasing demands on the quality of electronic ceramics requires a well-controlled correlation between particle morphology and processing conditions. Since mechanical activation is one of the methods for modification of ...
BaTi0.975Sn0.025O3/BaTi0.85Sn0.15O3 functionally graded materials: master sintering curves and electrical properties
(Belgrade : Institute of Technical Sciences of SASA, 2009)
The most important aim in the design and processing of functionally graded materials (FGMs) is to obtain high-quality microstructure, and to produce devices free from any form of deformation. During sintering of BTS2.5/BTS15 ...
The influence of tribophysical activation on non-isothermal sintering of BaTiO3 ceramics
(Durnten-Zurich : Trans Tech Publications Ltd., 2006)
In this paper the influence of tribophysical activation on non-isothermal sintering of barium titanate has been investigated. BaTiO3 Powders were tribophysically activated in a planetary ball mill for 0, 60 and 120 min., ...
Enhancing Synthesis and Sintering of Zinc Titanate Using Mechanical Activation
(Progress in Advanced Materials and Processes, 2004)
Mechanical activation and sintering are used for obtaining zinc titanate, Zn2TiO4. Starting powder mixtures of ZnO and TiO2, in the molar ratio that is in accordance with the stoichiometry ofzinc titanate Zn2TiO4, were ...