Now showing items 1-10 of 89
The use of anodic linear sweep voltammetery analysis (ALSV) for characterization the copper anodes used for sulphur acidic waste solution treatment
(Tatranské Matliare : Slovak Society of Chemical Engineering, 2011)
This paper addresses on investigation the possibility of electrolytic treatment the sulphur acidic waste solution, obtained in the conventional electrolytic copper refining process. The copper anodes with non-standard ...
Non-noble metal composite cathodes for hydrogen evolution. Part I: The Ni–MoOx coatings electrodeposited from Watt’s type bath containing MoO3 powder particles
In this work the Ni–MoOx coatings have been prepared and characterized in view of their possible application as electrocatalysts for hydrogen evolution reaction (HER) in alkaline solution. The procedure of deposition of ...
Electrochemically synthesized polyaniline as support for lipase immobilization
Electrochemical synthesis of polyaniline support for enzyme immobilization provides easier control over the properties of obtained polymer and reduced risk of biocatalyst inactivation with residues of toxic compounds. In ...
Assessment of the effects of nanoparticles of CP/PLGA on cultures of different cell lines
(Belgrade : Institute of Technical Sciences of SASA, 2011)
The aim of this study was to examine the effects of nanoparticles of calcium phosphate/poly-(DL-lactide-co-glycolide) (NPs-CP/PLGA) on viability and growth of different cell lines in vitro. HeLa and MDCK cells were incubated ...
Impact of synthesis techniques on the structure and performances of LiFePO4 powders
Invited lecture at the International Electric Mobility Conference and Exhibition for Electric Mobility, 27th - 28th of October 2011, Ljubljana, Slovenia
Interaction of biomaterial containing calcium hydroxyapatite/poly-l-lactide with simulated body fluid
(Niš : University of Niš, Faculty of Medicine; Department of the Serbian Medical Society Niš, 2011)
The purpose of biomaterials is to replace a part or a function of the body in a safe, physiologically and economically acceptable way. The process of the reconstruction of bone defects has always been a big problem in ...
Sintering of Defect-Free BaTi0.975Sn0.025O3/BaTi0.85Sn0.15O3 Functionally Graded Materials
(Hoboken, NJ : John Wiley & Sons, 2011)
Shrinkage anisotropy could be one of the reasons of deformation during densification of functionally graded materials (FGMs). In this study we calculated coefficient of shrinkage anisotropy during sintering of BTS2.5/BTS15 ...
Proton conducting membranes based on photopolymerizable monomers
(ICOM 2011: Book of abstracts, 2011)
The proton exchange barrier or Proton Exchange Membrane (PEM) is the critical part of a fuel cell. The basic function of the membrane is to enable proton transport, while being simultaneously impermeable for electrons and ...
Preparation of LiFePO4/C composites by co-precipitation in molten stearic acid
The olivine type LiFePO4 is synthesized via a simple and inexpensive route by aqueous co-precipitation of an Fe(II) precursor material in molten stearic acid and subsequent heat treatment at different temperatures. Stearic ...
Photopolymerization of crosslinked proton conducting membranes
(Basel : RadTech Europe, 2011)
Several monomers and crosslinker in a broad range of concentrations in water and 1-Methyl-2-pyrrolidone (NMP) respectively were screened for their mechanical properties, water uptake and conductivity in porous membranes ...