Претраживање
Приказ резултата 31-40 од 90
Tesla's Fountain – Modeling and simulation in ceramics technology
(Elsevier, 2018)
In this paper, we present Tesla's Fountain in ceramics technology reconstruction from basic 3D model, simulation of the engine, light and fluids till the real materialization. As the one of the most important model purposes, ...
Investigation of thermally induced processes in corundum refractory concretes with addition of fly ash
(Springer Netherlands, 2015)
The effects that the fly ash addition has on the behavior of thermally resistant corundum concrete were discussed. Experimental program implied production of two refractory composites: "referent" concrete from 20 % of ...
High temperature sintering kinetics of a-Al2o3 powder
(Belgrade : International Institute for the Science of Sintering, 2003)
The sintering kinetics of a-Al2O3 powder is investigated in this paper Commercial a-Al2O3 powdered compacts were sintered close to 95 % of the theoretical density. The characteristic parameters of sintering kinetics were ...
Sintering of fly ash based composites with zeolite and bentonite addition for application in construction materials
(International Institute for the Science of Sintering, 2017)
Due to pozzolanic characteristics, fly ash is commonly used as a cement replacement in construction composites. Addition of natural clays with sorption ability (i.e. zeolite and bentonite) in to the fly ash based construction ...
Inert atmosphere processing of hydroxyapatite in the presence of lithium iron phosphate
(Journal of the European Ceramic Society, 2018)
The present study describes sintering behaviour of hydroxyapatite (HAp) upon addition of lithium iron phosphate (LFP) (1-10 wt.%) system in inert (Ar) atmosphere. The interaction between materials and melting of LFP ...
ZnO varistors prepared by direct mixing of constituent phases
(Sendai : Japan Institute of Metals, 2000)
ZnO varistors with non-linearity coefficients reaching 50 and low values of the leakage current (approximately 0.01 A/m2), were obtained by a method referred to as `direct mixing of constituent phases'. The method is based ...
Densification rate and phase structure changes during sintering of zinc titanate ceramics
(Elsevier, 2009)
Densification rate and phase structure changes during sintering of nanosized ZnTiO3 were studied. Sintering was performed in a dilatometer in two regimes: the first to 900 °C (heating rates 5, 10 and 15 °C/min) and the ...
Influence of MgO addition on the synthesis and electrical properties of sintered zinc-titanate ceramics
(Elsevier, 2009)
Starting mixtures of ZnO, TiO2 and MgO (0, 1.25 and 2.5 wt.% MgO) powders were mechanically activated for 15 min in a planetary ball mill. The powders obtained were sintered non-isothermally to temperatures between 800 and ...
The effect of mechanical activation on synthesis and properties of MgAl2O4 ceramics
(Elsevier, 2019)
Magnesium aluminate, MgAl2O4 and other alumina-based spinels are ceramics with high hardness, high melting point and mechanical strenght. Spinels can also be used as dielectrics in microwave applications. The goal of this ...
Analysis and modeling of sintering of Sr-hexaferrite produced by PIM technology
(Belgrade : International Institute for the Science of Sintering, 2011)
The powder injection moulding (PIM) technology is lately becoming more and more significant due to complex design possibilities and good repeatability. This technology requires optimization of all steps starting with ...