Претраживање
Приказ резултата 31-40 од 921
Biblioteke naučnoistraživačkih instituta i ustanova: zakonodavni okvir i praksa
(Čitalište, 2016)
U Srbiji postoji više od 70 akreditovanih naučnih instituta, ustanova i centara izuzetnih vrednosti, sa bibliotekama čiji knjižni fondovi često premašuju fondove fakultetskih biblioteka, sa bibliotekarima i knjižničarima ...
The influence of mechanical activation on sintering process of BaCO3-SrCO3-TiO2 system
(Belgrade : International Institute for the Science of Sintering, 2012)
In this article the influence of mechanical activation on sintering process of bariumstrontium-titanate ceramics has been investigated. Both non-activated and mixtures treated in a planetary ball mill for 5, 10, 20, 40, ...
Structural analysis of Zn2TiO4 doped with MgO
(Springer, 2009)
The starting mixtures of ZnO, TiO2, and MgO (0, 1.25, and 2.5 wt.%) powders are mechanically activated in a high-energy planetary mill for 15 min and then sintered between 800 and 1100°C for 2 h. The influence of MgO ...
Injectable polydimethylsiloxane-hydroxyapatite composite cement
(Bio-Medical Materials and Engineering, 2003)
An injectable polydimethylsiloxane/hydroxyapatite (PDMS/HAp) composite cement was synthesised using linear PDMS and HAp (particles of about 100 nm in size) of different mass fractions. The effect of HAp mass fraction (5-60 ...
Effect of chemisorbed carbon monoxide on Pt/C electrode on the mechanism of the hydrogen oxidation reaction
(Elsevier, 2009)
The influence of poisoning of Pt catalyst by CO on the kinetics and mechanism of H2 oxidation reaction (HOR) at Pt/C electrode in 0.5 mol dm-3 HClO4, saturated with H2 containing 100 ppm CO, was examined with rotating disc ...
Assessment of Grain Size and Grain Refinement Efficiency by Calculation of Released Heat Attributed to Formation of Primary Aluminum Crystals During Solidification of Al7Si4Cu Alloy
(Springer Science and Business Media LLC, 2021)
Assessing heat released only related to the formation of primary crystals provides results with a significantly higher sensitivity than a traditional assessment of undercooling value. In this work, two similar Ti5B1 master ...
The influence of the starch coating on the magnetic properties of nanosized cobalt ferrites obtained by different synthetic methods
(Elsevier, 2021)
To investigate the magnetic behavior of starch-coated cobalt ferrites, well-established synthetic methods, i.e., coprecipitation, mechanochemical, ultrasonically assisted coprecipitation, microemulsion, and microwave-assisted ...
Mechanochemical preparation and characterization of CaO·ZnO used as catalyst for biodiesel synthesis
(Elsevier, 2012)
In this study, the synthesis of biodiesel or fatty acid methyl esters (FAME) from sunflower oil and methanol using CaO·ZnO catalyst was investigated. Catalyst was synthesized by ball milling of Ca(OH)2 and ZnO powder mixture ...
The contribution of fractal nature to BaTiO3-ceramics microstructure analysis
(Elsevier, 2012)
The structure of BaTiO3 based materials can be controlled by using different technological parameters and different additives. In this paper, microstructure and dielectrical properties of Er2O3 doped BaTiO3-ceramics, ...
Determination of the zinc and cadmium contents in low-alloyed tin
(Belgrade : Serbian Chemical Society, 1999)
The method of anodic linear sweep voltammetry (ALSV) has been used to determine the content of Zn and Cd (up to 4% w/w) in eutectic type binary alloys with Sn. The alloy samples were prepared by casting. The effect of the ...