Претраживање
Приказ резултата 1-6 од 6
Influence of Bi2O3 on microstructure and electrical properties of ZnO-SnO2 ceramics
(Belgrade : International Institute for the Science of Sintering, 2007)
The effects of small amounts (0.5; 1.0 and 1.5 mol. %) of bismuth oxide on the microstructure and electrical properties of ZnO-SnO2 ceramics have been studied. Starting powders of ZnO and SnO2 were mixed in the molar ratio ...
Geometrical and electrical properties of NTC polycrystalline thermistors vs. Changes of sintering parameters
(Belgrade : International Institute for the Science of Sintering, 2006)
NTC thermistor powder was made of a Mn, Ni, Fe and Co oxide mixture calcinated at 1050°C / 60 min. The powder was milled in a ball mill down to an average particle diameter of 0.9 μm. Small disc shaped pills of the powder ...
Densification rate and phase structure changes during sintering of zinc titanate ceramics
(Elsevier, 2009)
Densification rate and phase structure changes during sintering of nanosized ZnTiO3 were studied. Sintering was performed in a dilatometer in two regimes: the first to 900 °C (heating rates 5, 10 and 15 °C/min) and the ...
Preparation of nanostructured Zn-Cr-O spinel powders by ultrasonic spray pyrolysis
(Elsevier Sci Ltd, Oxford, 2001)
Ultrasonic spray pyrolysis (1.7 MHz) has been applied for the generation of zinc chromium oxide submicronic (470 nm) particles from the corresponding metal nitrate solution. Heterogeneous gas-liquid/solid chemical reactions ...
Densification, Microstructure, and Electrical Properties of BaTiO3 (BT) Ceramics Prepared from Ultrasonically De-Agglomerated BT Powders
(Taylor & Francis, 2009)
In this study, a correlation between densification, microstructure, and electrical properties of BaTiO3 (BT) ceramics prepared from ultrasonically de-agglomerated BT powders has been analyzed. BT powders with the same ...
Evolution of the microstructure of disperse ZnO powders obtained by the freeze-drying method
(Lausanne : Elsevier Science, 2004)
Freeze-drying, as a cryochemical powder processing method is applied in the synthesis of ZnO submicrometer to narrosized powders. The process involves rapid freezing of the sprayed precursor solution, drying under vacuum ...