Претраживање
Приказ резултата 31-40 од 45
Thermal diffusivity of sintered 12CaO-7Al2O3
(Belgrade : International Institute for the Science of Sintering, 2003)
The thermal diffusivity and some electrical transport properties of sintered 12CaO-7Al2O3 were determined using a photoacoustic method with a transmission detection configuration. The thermal diffusivity, coefficient of ...
Analysis of the initial-stage sintering of mechanically activated SrTiO3
(ETRAN, 2019)
The initial-stage of sintering plays a significant role in determining the final microstructure that defines the main characteristics of electroceramics materials such as functional properties. In this article non-isothermal ...
Synthesis of barium-zinc-titanate ceramics
(Belgrade : International Institute for the Science of Sintering, 2012)
Mixtures of BaCO3, ZnO and TiO2 powders, with molar ratio of 1:2:4, were mechanically activated for 20, 40 and minutes in a planetary ball mill. The resulting powders were compacted into pellets and isothermally sintered ...
Sintering of cordierite in the presence of MoO3 and crystallization analysis
(Belgrade : International Institute for the Science of Sintering, 2014)
Cordierite (MAS) is difficult to sinter because of the very narrow sintering temperature range (1300-1400ºC). Because a low temperature process is desirable, it is necessary to find functional ads which can allow easier ...
The fractal nature approach in ceramics materials and discrete field simulation
(ETRAN, 2018)
In this paper, we present experimental data of static fractals and compare the results with theoretical analysis obtained using dynamic particle simulation. The fractal simulator presented in this manuscript is pioneer ...
Advantages of combined sintering compared to conventional sintering of mechanically activated magnesium titanate
(Belgrade : International Institute for the Science of Sintering, 2014)
In this article, the advantages of combined sintering in comparison with the conventional one, of mechanically activated magnesium titanate ceramic were investigated. The stoichiometric mixtures of MgO and TiO2 were ...
Mechanical properties and microstructure fractal analysis of refractory bauxite concrete
(Belgrade : International Institute for the Science of Sintering, 2015)
The surface topography analysis via fractals as a means of explanation of composite materials mechanical and microstructural characteristics has hardly been reported so far. This study proposes a method of fractal analysis ...
Multiferroic Heterostructure BaTiO3/ε-Fe2O3 Composite Obtained by in situ Reaction
(Belgrade : International Institute for the Science of Sintering, 2021)
Solid-state reaction between BaTiO3 and Fe2O3 was used to produce a multiferroic heterostructure composite. Commercial BaTiO3 and Fe(NO3)3•9H2O were suspended in ethanol for 30 minutes in an ultrasound bath. The prepared ...
Multi-phase (Zr,Ti,Cr)B2solid solutions: Preparation, multi-scale microstructure, and local properties
(Tsinghua University Press, 2023)
Multi-phase ceramics based on ZrB2, TiB2 and doped with CrB2 and SiC were prepared by powder metallurgy and hot pressing to explore the possibility of obtaining multi-scale microstructures by super-saturation of complex ...
Influence of mechanical activation on synthesis and properties of the MgO-TiO2 system
(Belgrade : International Institute for the Science of Sintering, 2007)
Materials applied in electronics such as multilayer capacitors are an important field of ceramic materials. Magnesium titanate based dielectric materials are used for producing type-I capacitors. A common way of obtaining ...