Претраживање
Приказ резултата 1-10 од 12
Statistical Analysis of the Influence of Temperature on Microstructure Contact Surfaces on BaTiO3 -ceramics Doped with Ho2O3
(Belgrade : Serbian Ceramic Society, 2014)
The materials based on BaTiO3 can be controlled using different technological parameters and different additives. We investigate the influence of different temperature levels of sintering (1320°C, 1350°C and 1380°C) on the ...
Influence of nitrogen and air atmosphere during thermal treatment on micro and nano sized powders and sintered TiO2 specimens
(Belgrade : International Institute for the Science of Sintering, 2014)
The influence of air and nitrogen atmosphere during heating on TiO2 nano and micro sized powders as well as sintered polycrystalline specimens was analyzed. Sintering of TiO2 nano and micro powders in air atmosphere was ...
Mechanical activation as sintering pre-treatment of talc for steatite ceramics
(Belgrade : Interenational Institute for the Science of Sintering, 2014)
The effect of vibratory mill induced mechanical activation on the change of the particle size, crystallinity and the phase transformations of the minerals present in the activated material, was studied with the purpose of ...
Properties of Magnesium Titanate Ceramic Obtained by Two Stage Sintering
(Belgrade : Serbian Ceramic Society, 2014)
The aim of this paper was investigation of structural and electrical properties of magnesium titanate ceramic obtained mechanochemically and subjected to two stage sintering process. Mixtures of MgO and TiO2 were treated ...
Properties of Magnesium Titanate Ceramic Obtained by Two Stage Sintering
(2014)
Poster presented at the III Serbian Ceramic Society Conference, 29th September - 1st October, Belgrade, 2014
Microstructure changes caused by thermal etching of sintered ZnTiO3
(2014)
Polishing and thermal etching was performed on ZnTiO3sintered ceramic. Two set of specimens were recorded, on higher 1200oC/1100oC sintered/etched, and lower 900oC/800oC sintered/etched. Phase composition, crystallite sizes ...
BaTiO3 – ceramics and Fractal Microstructure Analyses
(Belgrade : Serbian Ceramic Society, 2014)
Ceramics grain structure is difficult to describe by using traditional analytical methods based on Euclidean geometry. Using the fractal geometric/analytic methods instead, the new approach is offered in this paper. There ...
Fractal corrections of BaTiO3-ceramic sintering parameters
(Belgrade : International Institute for the Science of Sintering, 2014)
Morphology of ceramics grains and pores as well as Brownian character of particle dynamics inside ceramics specimen contributes to better understanding of the sintering process. BaTiO3-ceramics, studied in this paper, has ...
Sintering of cordierite in the presence of MoO3 and crystallization analysis
(Belgrade : International Institute for the Science of Sintering, 2014)
Cordierite (MAS) is difficult to sinter because of the very narrow sintering temperature range (1300-1400ºC). Because a low temperature process is desirable, it is necessary to find functional ads which can allow easier ...
Sintering of cordierite in the presence of MoO3 and crystallization analysis
(Belgrade : Materials Research Society of Serbia, 2014)
Cordierite (MAS) is difficult to sinter because of the very narrow sintering temperature range (1300-1400ºC). Because a low temperature process is desirable, it is necessary to find functional ads which can allow easier ...