Pretraživanje
Prikaz rezultata 31-40 od 101
Influence of Bi2O3 on microstructure and electrical properties of ZnO-SnO2 ceramics
(Belgrade : International Institute for the Science of Sintering, 2007)
The effects of small amounts (0.5; 1.0 and 1.5 mol. %) of bismuth oxide on the microstructure and electrical properties of ZnO-SnO2 ceramics have been studied. Starting powders of ZnO and SnO2 were mixed in the molar ratio ...
Investigation of sintering kinetics of ZnO by observing reduction of the specific surface area
(Belgrade : International Institute for the Science of Sintering, 2007)
Reduction of the specific surface area of porous ZnO during the sintering process was studied. ZnO powder was sintered at temperatures from 673 K to 1173 K. The decrease in the specific surface area was observed as a ...
The thermal and magnetic properties of the Fe89.8Ni1.5Si5.2B3C0.5 and Fe81B13Si14C2 amorphous alloys
(Belgrade : Institute for the Science of Sintering, 2015)
This paper investigates the thermal and magnetic properties of two iron based amorphous alloys with different Fe-content: Fe89.8Ni1.5Si5.2B3C0.5 and Fe81B13Si14C2. The XRD results show that the thermal induced structural ...
Analysis of isothermal sintering of zinc-titanate doped with MgO
(Belgrade : International Institute for the Science of Sintering, 2007)
The aim of this work was analysis of isothermal sintering of zinc titanate ceramics doped with MgO obtained by mechanical activation. Mixtures of ZnO, TiO2 and MgO (0, 1.25 and 2.5%) were mechanically activated 15 minutes ...
Synthesis and characterization of Cu-ZrB2 alloy produced by PM techniques
(Belgrade : International Institute for the Science of Sintering, 2014)
The copper alloy with 7vol.% ZrB2 examined in this study was consolidated via powder metallurgy processing (PM) by combining mechanical alloying and hot pressing process. Structural changes, morphological properties and ...
Impact of crushed mineral aggregate on the pumpability of concrete during transport and placement
(International Institute for the Science of Sintering, 2016)
In the spirit of the sustainable buildings, and with the goal of protection of river courses, in the near future an already announced directive ordering closing down of a large number of river aggregate dredging operations ...
Photoacoustic properties of single crystal PbTe(Ni)
(Belgrade : International Institute for the Science of Sintering, 2007)
Single crystals of PbTe(Ni) were investigated by the photoacoustic method. They were produced using the Bridgeman method. These crystals have a sodium chloride cubic lattice and could be cleaved paralel to the plane ...
Geometrical and electrical properties of NTC polycrystalline thermistors vs. Changes of sintering parameters
(Belgrade : International Institute for the Science of Sintering, 2006)
NTC thermistor powder was made of a Mn, Ni, Fe and Co oxide mixture calcinated at 1050°C / 60 min. The powder was milled in a ball mill down to an average particle diameter of 0.9 μm. Small disc shaped pills of the powder ...
High temperature sintering kinetics of a-Al2o3 powder
(Belgrade : International Institute for the Science of Sintering, 2003)
The sintering kinetics of a-Al2O3 powder is investigated in this paper Commercial a-Al2O3 powdered compacts were sintered close to 95 % of the theoretical density. The characteristic parameters of sintering kinetics were ...
Thermal diffusivity of single crystal Bi0.9Sb0.1
(Belgrade : International Institute for the Science of Sintering, 2010)
A single crystal Bi0.9Sb0.1 ingot was synthesized using the Bridgman technique. Thermal diffusivity and electronic transport properties of single crystal cleaved plates (00l) were determined from PA photoacoustic phase and ...