Now showing items 1-10 of 134
Shungite – a carbon-mineral rock material: Its sinterability and possible applications
(Novi Sad : Faculty of Technology, University of Novi Sad, 2019)
The paper presents results of the influence of mechanical activation of shungite, a carbon-mineral rock material rich in silica and carbon, on its sintering behaviour, and obtaining of pure SiC ceramics. The mechanical ...
Influence of Point Defects Concentration on Densification Process and Optical Properties of Sintered ZnO Ceramics
(Belgrade : Materials Research Society of Serbia, 2015)
Zinc oxide is one of the most studied materials due to its potential applications in electronics, optoelectronics and spintronics. In the forms of single crystal and thin-film ZnO could be used as UV and blue light emitter, ...
Characterisation of Mn0.63Zn0.37Fe2O4 powders after intensive milling and subsequent thermal treatment
(Science of Sintering, 2017)
Commercial Mn-Zn powder (Mn0.63Zn0.37Fe2O4, 93 wt. % and Fe2O3 7 wt. %) was milled 0.5, 1, 2 and 4 hours in a planetary ball mill. The goal was to observe intensive milling influences on oxidation and reduction processes ...
Shungite - a Russian mineral: possible application as a microwave absorber
(Belgrade : Materials Research Society of Serbia, 2018)
The paper presents results of investigation of the influence of mechanical activation of shungite, a Russian natural mineral rich in silica and carbon, on its sintering behavior. The mechanical activation of the starting ...
Influence of nitrogen and air atmosphere during thermal treatment on micro and nano sized powders and sintered TiO2 specimens
(Belgrade : International Institute for the Science of Sintering, 2014)
The influence of air and nitrogen atmosphere during heating on TiO2 nano and micro sized powders as well as sintered polycrystalline specimens was analyzed. Sintering of TiO2 nano and micro powders in air atmosphere was ...
Statistical Analysis of the Influence of Temperature on Microstructure Contact Surfaces on BaTiO3 -ceramics Doped with Ho2O3
(Belgrade : Serbian Ceramic Society, 2014)
The materials based on BaTiO3 can be controlled using different technological parameters and different additives. We investigate the influence of different temperature levels of sintering (1320°C, 1350°C and 1380°C) on the ...
Influence of mechanochemical activation on sintering of cordierite ceramics with the presence of Bi2O3 as a functional additive
(Belgrade : Materials Research Society of Serbia, 2011)
According to its exceptional electrical characteristics, such as low temperature expansion coefficient, low dielectric constant and good mechanical properties, cordierite, 2MgO⋅2Al2O3⋅5SiO2, represents very attractive ...
Properties of Magnesium Titanate Ceramic Obtained by Two Stage Sintering
Poster presented at the III Serbian Ceramic Society Conference, 29th September - 1st October, Belgrade, 2014
Structural and electrical properties of barium-zinc-titanate ceramics sintered at 1300ºc
(Belgrade : Institute of Technical Sciences of SASA, 2010)
The aim of this work was an investigation of structural and electrical properties of sintered barium-zinc-titanate ceramics. Mixtures of BaCO3, ZnO and TiO2 were mechanically activated in a planetary ball mill up to 80 ...
Sinterovanje i svojstva sinterovanog ZnTiO3
(Belgrade : University of Belgrade, Faculty of Physical Chemistry, 2011)
Ultrafini prah cink-metatitanata veličine čestica 40 do 80 nm podvrgnut je prilikom sintetskog dela tretmana uticajima pritiska i temperature korišćenjem procesa presovanja i reakcionog sinterovanja. S obzirom na nestabilnost ...