Now showing items 1-10 of 169
Analiza osetljivosti debeloslojnih NTC termistora na promene temperature i protoka vazduha
(Čačak : University of Kragujevac, Faculty of Technical Sciences, 2006)
NTC termistori na bazi Mn, Ni, Co i Fe oksida za potrebe debeloslojnih senzora pripadaju oblasti istraživačkog i primenjenog rada sa ciljem realizacije senzora prilagođenih po obliku, prenosu toplote i brzini odziva fizičkim ...
ZnO varistors prepared by direct mixing of constituent phases
(Sendai : Japan Institute of Metals, 2000)
ZnO varistors with non-linearity coefficients reaching 50 and low values of the leakage current (approximately 0.01 A/m2), were obtained by a method referred to as `direct mixing of constituent phases'. The method is based ...
Sintering of fly ash based composites with zeolite and bentonite addition for application in construction materials
(International Institute for the Science of Sintering, 2017)
Due to pozzolanic characteristics, fly ash is commonly used as a cement replacement in construction composites. Addition of natural clays with sorption ability (i.e. zeolite and bentonite) in to the fly ash based construction ...
Kosanović, D., Blagojević, V.A., Maričić, A., Aleksić, S., Pavlović, V.P., Pavlović, V.B., Vlahović, B., 2018. Influence of mechanical activation on functional properties of barium hexaferrite ceramics. Ceramics International 44, 6666–6672. https://doi.org/10.1016/j.ceramint.2018.01.078: Supplement
(Ceramics International, 2018)
Rietveld analysis of XRD patterns of mechanically activated Fe:BaTiO3 powder mixtures sintered at 1200°C
Densification rate and phase structure changes during sintering of zinc titanate ceramics
Densification rate and phase structure changes during sintering of nanosized ZnTiO3 were studied. Sintering was performed in a dilatometer in two regimes: the first to 900 °C (heating rates 5, 10 and 15 °C/min) and the ...
Influence of nitrogen and air atmosphere during thermal treatment on micro and nano sized powders and sintered TiO2 specimens
(Belgrade : International Institute for the Science of Sintering, 2014)
The influence of air and nitrogen atmosphere during heating on TiO2 nano and micro sized powders as well as sintered polycrystalline specimens was analyzed. Sintering of TiO2 nano and micro powders in air atmosphere was ...
Statistical Analysis of the Influence of Temperature on Microstructure Contact Surfaces on BaTiO3 -ceramics Doped with Ho2O3
(Belgrade : Serbian Ceramic Society, 2014)
The materials based on BaTiO3 can be controlled using different technological parameters and different additives. We investigate the influence of different temperature levels of sintering (1320°C, 1350°C and 1380°C) on the ...
The Influence of Mechanical Activation on Sintering Process of BaCO3-SrCO3-TiO2 System
(Belgrade : Serbian Ceramic Society, 2012)
In this article the influence of mechanical activation on sintering process of barium-strontiumtitanate ceramics has been investigated. Both non-activated and mixtures treated in planetary ball mill for 5, 10, 20, 40, 80 ...
Synthesis, characterization and sintering properties of Zr-doped hydroxyapatite
(Belgrade : Institute of Technical Sciences of the Serbian Academy of Sciences and Arts, 2011)
Improving of material characteristics could be achieved in different ways, but it is always connected with the issue of impairing the other functional properties. Hydroxyapatite bioceramics lacks of insufficient mechanical ...
The influence of mechanical activation on sintering process of BaCO3-SrCO3-TiO2 system
(Belgrade : International Institute for the Science of Sintering, 2012)
In this article the influence of mechanical activation on sintering process of bariumstrontium-titanate ceramics has been investigated. Both non-activated and mixtures treated in a planetary ball mill for 5, 10, 20, 40, ...