Претраживање
Приказ резултата 121-130 од 194
TiO2 nanotubes film/FTO glass interface: Thermal treatment effects
(ETRAN, 2022)
Pure Ti films deposited by radio-frequency magnetron sputtering on FTO glass were anodized to fabricate TiO2 nanotubes (NTs) arrays. The TiO2 NTs/FTO samples were sintered at 450, 550 and 630°C, in ambient air. The thermal ...
Structural And Functional Investigation Of Fe/Pb/Zr-co-doped Barium Titanate Ceramics: From Theory To The Experiment
(Belgrade : Serbian Ceramic Society, 2021)
Mixtures of high purity powders of 50 mass% Fe, 4 mass% Pb, 3 mass% Zr and 43 mass% BaTiO3 were activated in a rotary ball mill for durations ranging from 30 min to 300 min; samples were then sintered in the air atmosphere ...
The effect of ball milling on properties of sintered manganese-doped alumina
(Elsevier, 2019)
Alumina-based compounds have many technological applications and attract great attention even after decades of investigation, due to their good chemical, electrical, and mechanical properties. A mixture of several alumina ...
Structural and Electrical Properties of Barium-Zinc-Titanate Ceramics Sintered at 1300°C
(2010)
Poster presented at the 12th Annual Conference of the Materials Research Society of Serbia - YUCOMAT 2010, Herceg Novi, Montenegro, September 6–10, 2010.
Densification, Microstructure, and Electrical Properties of BaTiO3 (BT) Ceramics Prepared from Ultrasonically De-Agglomerated BT Powders
(Taylor & Francis, 2009)
In this study, a correlation between densification, microstructure, and electrical properties of BaTiO3 (BT) ceramics prepared from ultrasonically de-agglomerated BT powders has been analyzed. BT powders with the same ...
Synthesis and sintering of high-temperature composites based on mechanically activated fly ash
(Belgrade : International Institute for the Science of Sintering, 2012)
Amount of fly ash which is and yet to be generated in the coming years highlights the necessity of developing new methods of the recycling where this waste can be reused in significant quantity. A new possibility for fly ...
Investigation of zinc stannate synthesis using photoacoustic spectroscopy
(Belgrade : International Institute for the Science of Sintering, 2007)
Mixtures of ZnO and SnO2 powders, with molar ratio of 2:1, were mechanically activated for 40, 80 and 160 minutes in a planetary ball mill. The resulting powders were compacted into pellets and non-isothermally sintered ...
New Frontiers: Miniaturization and Higher Level BaTiO3 -Ceramics Microelectronics Circuits Integration
(Belgrade : Serbian Ceramic Society, 2012)
Since that the scientific and technological efforts to further miniaturization, "better packaging" and higher levels of integration of electronic components and subsystems, and modern microelectronics devices are increasingly ...
Structural and electrical properties of sintered zinc-titanate ceramics
(Elsevier, 2009)
The aim of this work was an investigation of structural and electrical properties of sintered zinc-titanate ceramics obtained by mechanical activation. Mixtures of ZnO and TiO2 were mechanically activated in a planetary ...
Thermal diffusivity of sintered 12CaO-7Al2O3
(Belgrade : International Institute for the Science of Sintering, 2003)
The thermal diffusivity and some electrical transport properties of sintered 12CaO-7Al2O3 were determined using a photoacoustic method with a transmission detection configuration. The thermal diffusivity, coefficient of ...